|
A router is a woodworking tool used to rout out (hollow out) an area in the face of a piece of wood. It was a tool particularly used by pattern makers and staircase makers and consisted of a broad-based wooden hand plane with a narrow blade projecting well beyond its base plate gaining it the nickname Old Woman's Tooth. Since about 1960, it has been replaced by the modern spindle router, which was designed for the same work, although the first electric hand routers appeared in the years just after World War I. Further refinement produced the Plunge Router, invented by Elu (now part of deWalt) in Germany in the late 1940s. This is even better adapted for many types of work. Today, traditional hand-powered routers are often called router planes. Modern routers are often used in place of traditional moulding planes or spindle moulder machines for edge decoration (moulding) of timber. Related to the router, is a smaller lighter version designed specifically for trimming laminates. It can be used for smaller general routing work. For example with an appropriate jig it can be used recessing door hinges and recessing lock faceplates etc.
The Router The tool usually consists of a base housing a vertically mounted universal electric motor with a collet on the end of its shaft. The bit is height-adjustable to allow protrusion through an opening in a flat sole plate, usually via adjusting the motor-mounting height (the mechanism of adjustment is widely varied among manufacturers). Control of the router is derived from a handle or knob on each side of the device, or by the more recently developed "D-handle". There are two standard types of router — plunge and fixed. When using a plunge-base router, the sole of the base is placed on the face of the work with the cutting bit raised above the work, then the motor is turned on and the cutter is lowered into the work. With a fixed-base router, the cut depth is set before the tool is turned on. The sole plate is then either rested flat on the workpiece overhanging the edge so that the cutting bit is not contacting the work (and then entering the work from the side once the motor is turned on), or the sole plate is placed at an angle with the bit above the work and the bit is "rocked" over into the work once the motor is turned on. In each case, the bit cuts its way in, but the plunge router does it in a more refined way, although the bit used must be shaped so it bores into the wood when lowered. The baseplate (sole plate) is generally circular (though this, too, varies by individual models) and may be used in conjunction with a Fence attached to the base, which then braces the router against the edge of the work, or via a straightedge clamped across the work to obtain a straight cut. Other means of guiding the machine include the template guide bushing secured in the base around the router cutter, or router cutters with built-in guide bearings. Both of these run against a straight edge or shaped template. Without this, the varying reaction of the wood against the torque of the tool makes it impossible to control with the precision normally required. As an alternative, the tool can also be mounted in an inverted orientation below router tables and used as a miniature spindle-Shaper. The machine is mounted below the table in the manner akin to a Circular saw mounted like a table saw. With such a set-up, it is often advisable that the work be passed over it along a fence. With some router table arrangements it is possible to adjust the bench to give the effect of tilting a saw bench so as to cut with the axis of the tool at an angle other than 90° to the face of the work.
Trackback(0)
 |
TrackBack URI for this entry
Subscribe to this comment's feed
